Keep the complete CNC or VMC machine in view: spindle, drives, controls and auxiliaries. We review its electrical input and site voltage before recommending a servo stabilizer.
Discuss your applicationA clear equipment list helps us review the servo configuration for your site.
Share machine nameplatesCNC alarms and trips can arise from wiring, phase imbalance, drives, machine settings or supply voltage. A qualified electrician should check the supply and the machine fault history before deciding that a stabilizer is the right remedy.
Do not choose KVA from the machine’s name alone. Review the complete electrical input, simultaneous loads, starting behavior and the machine manufacturer’s requirements. A spindle motor’s mechanical rating does not necessarily represent the whole machine’s electrical demand.
Measured low and high input voltages determine the required correction range. KEVOR’s standard nominal output is 230 V AC single phase or 400 V AC three phase, with a custom output reviewed when the machine requires it.
Confirm phase balance, earthing, cable and breaker ratings, ventilation and service access. Voltage regulation does not replace machine protection, suitable surge protection or a UPS where continuity during an outage is required.
A spindle’s mechanical kW rating does not describe the complete CNC input. Include the drives, control system, coolant equipment and any separately supplied auxiliaries. For multiple machines, record which operate together.
Send the full machine nameplate and the OEM’s required supply voltage. Compare the offered output tolerance with the machine’s specification.
Read the KVA selection guide
Do not choose KVA from the machine’s name alone. Review the complete electrical input, simultaneous loads, starting behavior and the machine manufacturer’s requirements. A spindle motor’s mechanical rating does not necessarily represent the whole machine’s electrical demand.
Air-cooled designs release heat to the surrounding air and need suitable ventilation. Oil-cooled designs transfer heat through insulating oil and need an appropriate enclosure location and service access. We select cooling from the offered design, load, operating hours and site conditions.
No. The application name is a starting point. The actual electrical load, supply phase, voltage window, starting demand and equipment requirements determine suitability.
Send your machine details on WhatsApp, or leave your number. We’ll help you take the next step.
Send a nameplatePrefer to talk? +91 76696 69400Just your name and number to get started.
